Repeat Sequence without Input

Applies the sequence that was set using Set Member Sequence with Input (or the sequence in line 1 on the Sequence Names list) to the one member that you select.

Step-By-Step
Tips and Tricks
Related Tools

1 . Invoke Repeat Sequence without Input using the Find Tool by searching the command name and clicking the icon, which is pictured above.

Learn more about alternative methods for launching commands.

2 . The status line prompts "Select member to sequence" and Select - Pan - Menu mouse bindings remain active. Left-click (Select) a member to set its sequence. The sequence that was last set using Set Member Sequence with Input (or the sequence in line 1 on the Sequence Names list) is applied to the selected member. The status line informs you that the member's sequence was changed. If that member was already set to that sequence, the status line informs you that the member is currently set to that sequence.

Alternative: Right-click (Menu) and select Cancel or press the Esc key to end the command.

If you did not first set a sequence name with Set Member Sequence with Input prior to using this command, the sequence in line 1 on the Sequence Names list is used.
You can optionally preselect a member before you invoke this command.
If the setup option Break member piecemarks apart by is set to Sequence or Zone, some members may be assigned new piecemarks as you change their sequences. The same is true if the box is checked for Break submaterial marks apart by sequence or Break submaterial marks apart by zone.
The Maximum number of sequences must be set to a number greater than 1 if you want to change sequences using this operation. You may also want to set up specific Sequence Names before you begin.
It does not matter if the member is displayed in stick or a solid form.

Set Member Sequence with Input (use before Repeat Sequence without Input)
Update Attributes (alternative for assigning sequences)
Dividing a Model into Sequences/Zones (overview)
Maximum sequences (Home > Project Settings > Job > Modeling > Zone and Sequence)
Sequence Names (Home > Project Settings > Job > Modeling > Zone and Sequence > press Sequence Names)
Break major marks apart by (Home > Project Settings > Job > Piecemarking > Member & Material Piecemarking > the Main Member tab)